Atlas Copco Filter DD17
Atlas Copco Filter DD17 is a core part of the precision filter and its quality directly affects the use of the filter. Atlas Copco Filter DD17 produced by our company is made of foreign or domestic high-quality filter material and stainless steel skeleton.
Atlas Copco Filter DD17 Product Introduction:
Atlas Copco Filter DD17 is a core part of the precision filter and its quality directly affects the use of the filter. Atlas Copco Filter DD17 produced by our company is made of foreign or domestic high-quality filter material and stainless steel skeleton. It has the characteristics of corrosion resistance, heat resistance, pressure resistance and wear resistance. It is widely used in petroleum, chemical, metallurgy, water treatment and other fields. The glass fiber used can be very effective in separating lubricating oil droplets having a diameter of from 50 to 0.01 μm. It does not have to be absorbed or absorbed during filtration. And it is very effective and superior to other materials.
Atlas Copco Filter DD17 Product Characteristics:
Skeleton: Stainless steel
Working temperature: 80 °C
Maximum working pressure difference: 20 (MPa) MPa
Filtration accuracy: 0.01μm
Residual oil content (ppm): 0.01
Performance: acid, waterproof, anti-static
Filter material: high quality sponge
End cap: can be marked
Atlas Copco Filter DD17 Product Application：
1.Thermal power and nuclear power: used for purification of steam turbines, boiler lubrication systems, speed control systems, bypass control systems, feed pumps, fans and dust removal systems.
2.Machining equipment: used in the lubrication system and compressed air purification of paper machinery, mining machinery, injection molding machines and large precision machinery, dust recovery and filtration of tobacco processing equipment and spraying equipment.
Atlas Copco Filter DD17 Installation Method：
Atlas precision filter installation should pay attention to:
a.. The working pressure should not exceed the maximum pressure indicated by the filter.
b. The filter is usually installed after the aftercooler and the gas tank, as close as possible to the point of use and the lowest temperature.
c. The filter should not be installed after the quick opening valve and prevent backflow and shock.
d. The filter should be installed vertically and leave enough space underneath to replace the filter element.
e. Larger filters should be properly supported in the pipeline.